HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)
Status Comparison
212 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Target Site Terminal Emulator Session
1. Using a serial cable, connect the COM port of a laptop computer or another computer to
the corresponding serial port on the HSG80 controllers.
2. Start a terminal emulator session that is capable of capturing text to a file (which is later
saved as step 6 of the SHOW Commands procedure). Use the following settings: 9600
baud, 8 bits, no parity, 1 stop bit, XON/XOFF.
Issuing SHOW Commands
1. To see the full information on this controller, issue the CLI command:
SHOW THIS_CONTROLLER FULL
You should see a display similar to that shown in Example Display 1.
2. To see the information for all association sets known to the controller pair, issue the CLI
command:
SHOW ASSOCIATIONS FULL
You should see a display similar to that in Example Display 2 for each association set.
3. To see information for all remote copy sets known to the controller pair, issue the CLI
command:
SHOW REMOTE_COPY FULL
You should see a display similar to that in Example Display 3 for each remote copy set.
4. To see information for all units configured to the controller, issue the CLI command:
SHOW UNITS FULL
You should see a display similar to that in Example Display 4 for each unit.
5. To see the connection name, operating system, controller, controller port, adapter ID
address, online or offline status, and unit offset, issue the CLI command:
SHOW CONNECTIONS
You should see a display similar to that in Example Display 5 for each connection.
6. Print and save two copies of the file started during the terminal emulator session procedure
(step 2). Save one copy at each site. This file contains the text captured in steps 1-5 of the
SHOW commands.
Example Display 1 corresponds to step 1 of the “Issuing SHOW Commands” section:
Example Display 1
Controller:
HSG80 ZG91412410 Software V85P, Hardware E05
NODE_ID = nnnnnnnnnnn
ALLOCATION_CLASS = 0
SCSI_VERSION = SCSI-2
Configured for MULTIBUS_FAILOVER with ZG91416136
In dual-redundant configuration
Device Port SCSI address 6
Time: NOT SET
Command Console LUN is lun 0 (NOIDENTIFIER)