HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
79Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Note: If you use scripting to automate failover and failback operations, do not use dashes (hyphens)
as separators in your naming convention—use underscores instead. Dashes are not allowed by the
Perl scripting language.
T 1. We suggest that you use the worksheet in Figure 19 on page 76 when renaming your hosts.
T 2. When you have completed the worksheet, rename the connections:
RENAME !NEWCONxx TargetHostConnectionNamex
RENAME !NEWCONxx TargetHostConnectionNamey
Example: rename !NEWCONxx HostB1
Example: rename !NEWCONxx HostB2
T 3. Set the operating system for each connection to Tru64 UNIX:
SET TargetHostConnectionNamex OPERATING_SYSTEM = TRU64_UNIX
Example: set HostB1 operating_system = tru64_unix
T 4. When you have finished renaming your host connections, issue the following command to
see your settings:
SHOW CONNECTIONS
You should see a display similar to that in Example Display 15.
Example Display 15
Connection Unit
Name Operating system Controller Port Address Status Offset
HostB1 Tru64_UNIX THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
HostB2 Tru64_UNIX OTHER 1 200013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
Update Switch Zones
The switch zones created earlier must be updated with the host connection information (refer
to Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for detailed information
on zone creation):
T 1. On the top fabric, add the host connection to the zone that contains port 1 of the top target
controller.
T 2. On the bottom fabric, add the host connection to the zone that contains port 1 of the
bottom target controller.
Your Tru64 UNIX host is now configured to use DRM. Execute this procedure for each Tru64
UNIX host present at the target site. After configuring the target site hosts, go to the section
titled “Configure the Controllers at the Initiator Site” on page 100.