HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
96 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Example Display 21
Connection Unit
Name Operating system Controller Port Address Status Offset
HostB1 NETWARE THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
HostB2 NETWARE OTHER 1 200013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
Update Switch Zones
The switch zones created earlier must be updated with the host connection information (refer
to Chapter 6, “Configuring the Optional Advanced DRM Solutions,” for detailed information
on zone creation):
T 1. On the top fabric, add the host connection to the zone that contains port 1 of the top target
controller.
T 2. On the bottom fabric, add the host connection to the zone that contains port 1 of the
bottom target controller.
Your NetWare host is now configured to use DRM. Execute this procedure for each NetWare
host present at the target site. After configuring the target site hosts, go to the section titled
“Configure the Controllers at the Initiator Site” on page 100.
Sun Solaris
Before beginning this procedure, make sure that your host is up to date with Solaris operating
system patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
T You must install at least two HBAs in each host system and they must be installed in pairs.
Record the HBA WWID for use later in this section. Refer to the Compaq StorageWorks
64-Bit PCI-to-Fibre Channel Host Bus Adapter User Guide for installation instructions. The
user guide is located at:
http://h18004.www1.hp.com/products/storageworks/techdoc/adapters/AA-RKPDB-TE.html. .
Note: Do not attach your fiber connections to the HBAs until instructed to do so.
WARNING: PCI and Sbus HBAs cannot coexist on the same host.