HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
97Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Connect the Host to the SAN
Use your established cabling policy to connect the host to the Fibre Channel switch.
T 1. Use 50-micron, multimode fiber optic cable to connect one adapter of each pair to the top
Fibre Channel switch.
T 2. Use 50-micron, multimode fiber optic cable to connect the other adapter of each pair to the
bottom Fibre Channel switch.
For example, if there are four adapters in a server, the first and third adapters must be
connected to the top Fibre Channel switch and the second and fourth adapters must be
connected to the bottom Fibre Channel switch.
Install the Solaris Platform Kit
Install the Solaris platform kit as specified by the instructions in the HP StorageWorks HSG80
ACS Solution Software Version 8.7 for Sun Solaris Installation and Configuration Guide. Note
that DRM requires the following deviations from the procedures when you install the HBAs:
■ Loop Mode. Disregard references to Loop Mode. Loop Mode is not supported in DRM.
■ Fabric Mode. Ensure that the top HBA receives the world wide port number (WWPN) of
the corresponding top port 1 address of the controller. Ensure that the bottom HBA
receives the WWPN of the corresponding bottom port 1 address of the controller.
Note: The HBA drivers and the SWCC agent are installed in this section. See Table 3-1 in the
HP StorageWorks HSG80 ACS Solution Software Version 8.7 for Sun Solaris Installation and
Configuration Guide
for a list of installed packages. SWCC is configured (optional) in a later
step.
T 1. Reboot the hosts using the reboot -- –r command.
T 2. Verify that the connection between the host and the switch has been made:
SHOW CONNECTIONS
You should see a display similar to that in Example Display 22.
Example Display 22
Connection Unit
Name Operating system Controller Port Address Status Offset
!NEWCON00 WINNT THIS 1 210013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn
!NEWCON01 WINNT OTHER 1 200013 online 0
HOST_ID=nnnn-nnnn-nnnn-nnnn . . . . ADAPTER_ID=nnnn-nnnn-nnnn-nnnn