HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Preparing the Host System 3–23
4. When all partitions have been formatted, close Disk Administrator. At this point, the
configuration has been completed, and is recognized by Windows NT or Windows
2000.
5. Changes to RAID Array Configuration
6. Before making changes, backup your system.
Removing Disk Partitions
NOTE: Before making changes, back up your system.
When making changes to an existing RAID Array configuration, any existing disk
partitions to be changed (or removed) must first be deleted using Windows NT Disk
Administrator or Windows 2000 Disk Management. After they have been deleted, you
may use the CLI to create new Storagesets.
1. From Disk Administrator or Disk Management, click the partition you wish to delete.
2. Access the Partition menu and choose Delete.
3. Continue selecting and deleting the partitions until you have deleted all the partitions
you wish. When finished, click Commit Changes Now. You may now reconfigure the
subsystem using the CLI.
4. Restart your system so Windows NT or Windows 2000 will recognize the changes. In
Windows 2000 you can also rescan from Disk Management.