HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

4–6 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
NOTE: Put your most important client systems at the top of this list and the client systems that
are connected infrequently to the network at the bottom. The Agent first contacts the client
systems that are located at the top of the list.
The following describes how the Transmission Control Protocol/Internet Protocol
(TCP/IP) and the Simple Network Management Protocol (SNMP) work with SWCC:
9. Select one of the following for your access privileges: overall status, detailed status,
and configuration. The access privilege level controls the client system's level of
access to the storage subsystems. The following explains the client system access
options:
10. Click Add Client to add the client system entry to the Client list. For more information
on adding, deleting, or modifying a Client, See “Reconfiguring the Agent” on page 7.
11. Click Next to continue. If the Windows NT Agent Configuration Step 3 of 3 window
appears, go to step 13.
Table 4–3 Client System Notification Options
Options SWCC Function
Transmission Control Protocol/Internet Protocol
(TCP/IP)
■ Automatically updates the Storage Window of
subsystem changes
■ Required for event logging and pager
notification
■ If you do not select TCP/IP, you will need to
refresh the Storage Window (depending on the
subsystem) to obtain the latest status of a
subsystem.
Simple Network Management Protocol (SNMP) ■ Requires you to use an SNMP-monitoring
program to view SNMP traps
Table 4–4 Client System Access Options
Options SWCC Function
Overall Status ■ Can use the Client to add a system to a Navigation Tree, set up a
pager, and view properties of the controller and the system
■ Cannot use Client to open a Storage Window
Detailed Status ■ Can use the Client to open a Storage Window, but you cannot make
modifications in that window
Configuration ■ Can use the Client to make changes in a Storage Window to modify a
subsystem configuration