HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–11
5. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window appears, go
to step 6.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the subsystem to update the
information? (Subsystem names will revert to default settings.)
If you click Yes, the software will automatically add entries for the new subsystems
and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.
6. Click Finish. The following message appears:
No subsystem information was added to the subsystem list. Subsystem list will not be created
or modified.
7. Click OK. The Welcome NT Agent Configuration Utility window appears.
8. Click Exit to quit the NT Agent Configuration Utility.
9. You must stop and restart the Agent for your changes to take effect. For instructions,
see “Stopping and Starting the Agent,” page 4–14.
Adding a Subsystem Entry
You must tell the Agent which subsystems to monitor.
CAUTION: Verify that you have the correct communication drive before you manually
add a subsystem.
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click Next to continue. You do not need to enter your password. The NT Agent
Configuration Step 2 of 3 window appears.
4. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window appears, go
to step 5.