HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

4–12 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the subsystem to update the
information? (Subsystem names will revert to default settings.)
If you click Yes, the software will automatically add entries for the new subsystems
and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.
5. Enter the name of the subsystem in the Selected Subsystem field. Enter the
communication drive letter and monitoring interval in seconds. The monitoring
interval is the rate at which the Agent queries the specified subsystem for status. A
reasonable monitoring interval in seconds would be 120.
When you select Subsystem Enabled, the subsystem is included in the Agent’s scans.
When Subsystem Enabled is selected, the software configures the storage.ini file so that
the subsystem selected in the dialog box is visible to the host. The storage.ini file holds
information about the RAID devices connected to your server.
6. Click Add Subsystem. The name of the added subsystem appears in the Storage
Subsystems field.
7. Click Finish. A message, warning you to restart your Agent, appears.
8. Click OK. You exit the NT Agent Configuration Utility.
9. You must stop and restart the Agent for your changes to take effect. For instructions,
see “Stopping and Starting the Agent,” page 4–14.
Modifying a Subsystem Entry
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click Next to continue. You do not need to enter your password. The NT Agent
Configuration Step 2 of 3 window appears.
4. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window appears, go
to step 5.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the subsystem to update the
information? (Subsystem names will revert to default settings.)