HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

4–14 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
If you click Yes, the software will automatically add entries for the new subsystems
and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.
5. Select the subsystem that you want to delete in the Storage Subsystems field. Click
Delete Subsystem.
6. Click Finish. A message, warning you to restart your Agent, appears.
7. Click OK. You exit the NT Agent Configuration Utility.
8. You must stop and restart the Agent for your changes to take effect. For instructions,
see “Stopping and Starting the Agent,” page 4–14.
Stopping and Starting the Agent
The Agent runs as a service in the background. When you stop the Agent, you are telling
the software to stop monitoring the tape controllers that were added to the Tape Controller
Management page.
From Windows NT
1. Double click Services in Control Panel.
2. Click Steam.
3. Click Stop or Start, then click Close.
4. Refresh the open Storage Windows for the HSG and HSZ controllers.
From Windows 2000
1. Click Start > Settings > Control Panel > Administrative Tools > Component Services.
2. Under Console Root, select Services (Local).
3. Under Services (Local), right-click Steam.
4. Click Stop or Start.
5. Refresh the open Storage Windows for the HSG and HSZ controllers.