HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

5–8 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
14. Turn on the switches, if not done previously.
If you want to communicate with the Fibre Channel switches through Telnet, set an IP
address for each switch. See the manuals that came with the switches for details.
Plug in the FC Cable and Verify Connections
15. Plug the Fibre Channel cable from the first host bus adapter into the switch. Enter the
SHOW CONNECTIONS command to view the connection table:
SHOW CONNECTIONS
16. Rename the connections to something meaningful to the system and easy to remember.
For example, to assign the name ANGEL1A1 to connection !NEWCON01, enter:
RENAME !NEWCON01 ANGEL1A1
For a recommended naming convention, see “Naming Connections,” page 1–13.
17. Specify the operating system for the connection:
SET ANGEL1A1 OPERATING_SYSTEM=WINNT
18. Verify the changes:
SHOW CONNECTIONS
Mark or tag all Fibre Channel cables at both ends for ease of maintenance.
Repeat Procedure for Each Host Adapter
19. Repeat step 16, 17, and 18 for each of that adapter’s host connections, or delete the
unused connections from the table.
20. For each host adapter, repeat steps 15 through 19.
Verify Installation
To verify installation for your Windows NT and Windows 2000 host, enter the following
command:
SHOW DEVICES