HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

5–10 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
The following figure shows a controller pair with failover cabling showing one HBA per
server with HSG80 controller in transparent failover mode.
Figure 5–3. Controller pair failover cabling
Configuring a Controller Pair Using CLI
To configure a single controller using CLI involves the following processes:
■ Configure Controller Settings.
■ Restart the Controller.
■ Set Time and Verify All Commands.
■ Plug in the FC Cable and Verify Connections.
■ Repeat Procedure for Each Host Adapter.
■ Verify Installation.
1. Enter a
SHOW THIS command to verify the node ID:
SHOW THIS
See “Worldwide Names (Node IDs and Port IDs),” page 1–27, for the location of the
sticker.
1 Controller A
2 Controller B
3 Host port 1
4 Host port 2
5 Cable from the switch to the host FC adapter
6 FC switch
CXO6887B
6
6
5
5
1
2
4
3