HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Configuration Procedures 5–13

When FRUTIL asks if you intend to replace the battery, answer “Y”:

Do you intend to replace this controller's cache battery? Y/N [N] Y

FRUTIL will print out a procedure, but will not give you a prompt. Ignore the

procedure and press Enter.

12. Set up any additional optional controller settings, such as changing the CLI prompt.

See the

SET THIS CONTROLLER/OTHER CONTROLLER command in the Compaq StorageWorks

HSG80 Array Controller ACS Version 8.6 CLI Reference Guide for the format of

optional settings. Perform this step on both controllers.

13. Verify that all commands have taken effect by entering the following command:

SHOW THIS

14. Verify node ID, allocation class, SCSI version, failover mode, identifier, and port

topology. The following display is a sample result of a

SHOW THIS command, with the

areas of interest in bold.

Controller:

HSG80 (C) DEC ZG09030200 Software V8.6F-1, Hardware E11

NODE_ID = 5000-1FE1-0000-0000

ALLOCATION_CLASS =

SCSI_VERSION = SCSI-3

Configured for dual-redundancy with 2GOPO30245

Device Port SCSI address 7

Time: 10-Mar-2001:12:30:34

Command Console LUN is lun 0

(IDENTIFIER = 88)

Host PORT_1:

Reported PORT_ID = 5000-1FE1-0000-0001

PORT_1_TOPOLOGY = FABRIC (standby)

Address = 210313

Host PORT_2:

Reported PORT_ID = 5000-1FE1-0000-0002

PORT_2_TOPOLOGY = FABRIC (fabric up)

Address = 210513

NOREMOTE_COPY

.......