HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Appendix B
Installing, Configuring, and Removing the Client
The following information is included in this appendix:
■ “Why Install the Client?,” page B–1
■ “Before You Install the Client,” page B–2
■ “Installing the Client,” page B–2
■ “Troubleshooting the Client Installation,” page B–3
■ “Adding the Storage Subsystem and its Host to the Navigation Tree,” page B–5
■ “Removing the Command Console Client,” page B–7
■ “Where to Find Additional Information,” page B–8
Why Install the Client?
The Client monitors and manages a storage subsystem by performing the following tasks:
■ Create mirrored device group (RAID 1)
■ Create striped device group (RAID 0)
■ Create striped mirrored device group (RAID 0+1)
■ Create striped parity device group (3/5)
■ Create an individual device (JBOD)
■ Monitor many subsystems at once
■ Set up pager notification