HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Maintenance and Service Guide (EK-G80MS-SA. C01, March 2005)

Replacing BA370, M2100 & M2200 Enclosure Elements
123HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Maintenance and Service Guide
 e. Exit VTDPY by pressing Ctrl+Y.
 f. Disable Failover mode, and take the controllers out of the
dual-redundant configuration by entering the following command:
SET NOFAILOVER
 3. For the controller to be replaced (), complete the following substeps:
 a. Ensure that the Reset button (see Figure 45 on page 115) is a constant
green.
 b. Remove the program card ESD cover (see Figure 46 on page 116).
 c. Remove the program card from the controller being replaced by
pressing the program card slot Eject button (see Figure 46 on
page 116).
 d. Save the ESD cover and program card in an antistatic bag or on a
grounded antistatic mat for use with the replacement controller.
 4. For the operational controller, complete the following substeps:
 a. Start FRUTIL by entering the following command:
RUN FRUTIL
FRUTIL automatically asks if you intend to replace the controller
cache battery.
 b. Enter N(o).
The FRUTIL Main Menu is displayed (see Figure 50 and Figure 51
on page 124).
Figure 50: FRUTIL Main Menu for a controller in a BA370
FRUTIL Main Menu:
1. Replace or remove a controller or cache module
2. Install a controller or cache module
3. Replace a PVA module
4. Replace an I/O module
5. Exit
Enter choice: 1,2,3,4,5 ->