HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Maintenance and Service Guide (EK-G80MS-SA. C01, March 2005)

Replacing BA370, M2100 & M2200 Enclosure Elements

136 HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software

Maintenance and Service Guide

8. Note the location for each DIMM in the cache module that is being replaced,

and install the DIMMs in the corresponding locations in the replacement

cache module. Use the following substeps to remove the DIMMs:

Note: To facilitate pressing down on the DIMM retaining clips, consider using the

eraser end of a pencil or a small screwdriver.

a. Press down on the DIMM retaining clips (see Figure 58) at both ends of

the DIMM being removed.

Figure 58: Removing or installing a DIMM

b. Gently remove the DIMM from the DIMM slot, and then place the

DIMM on an antistatic bag or a grounded antistatic mat.

c. Repeat substep 8a and substep 8b for each DIMM.

d. Proceed to the “Installing cache modules in single-controller

configurations” section that starts on page 137to install the DIMMs in the

replacement cache module.

1 DIMM

2 DIMM slot

3 DIMM retaining clips

5025