HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Maintenance and Service Guide (EK-G80MS-SA. C01, March 2005)

Common Replacement Information and Procedures

65HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software

Maintenance and Service Guide

12. Insert the controller and engage the retaining levers.

Note: In step a, ensure the program card is not installed in the replacement controller.

a. Insert the controller (without the program card installed) into the

appropriate bay, and engage the retaining levers.

b. Press and hold the controller Reset button (see Figure 22), insert the

program card, and continue holding the Reset button.

c. Press and hold controller Port #5 button (see Figure 22), release the

Reset button and continue holding the Port #5 button for an additional 5

to 20 seconds.

Figure 22: Controller Reset button and Port #5 button on the OCP

The nonvolatile memory in the replacement controller is updated and

halts with an LED code of 33.

d. Press and release the Reset button on the controller.

The controller restarts normally.

e. Wait at least 15 seconds after releasing the Reset button and then

immediately complete step 13 on page 66. Be sure to wait 15 seconds

before continuing to step 13 on page 66.

Note: A controller restart can take as long as 60 seconds, indicated by the temporary

cycling of the port LEDs and a flashing Reset button.

1 Reset button 2 Port #5 button and LED

123456

CXO7973A