HP StorageWorks HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide (AA-RV1FA-TE, March 2005)

Preparing the Host System
111HSG80 ACS Solution Software V8.8 for HP-UX Installation and Configuration Guide
For HP FC HBAs:
#ioscan -fn |grep fc
For HP FC HBAs, the output from the HP-based command is similar to:
Installing Host Bus Adapter
To make a physical connection, first install a host bus adapter.
Caution: Protect the host bus adapter board from electrostatic discharge by
wearing an ESD wrist strap. DO NOT remove the board from the antistatic
cover until you are ready to install it.
You need the following items to begin:
■ Host bus adapter board
■ The computer hardware manual
■ Appropriate tools to service your computer
The host bus adapter board plugs into a standard PCI slot in the host computer.
Refer to the system manual for instructions on installing PCI devices.
Note: Take note of the worldwide name (WWN) of each adapter. Do not power on
anything yet. For the FC switches to autoconfigure, power on equipment in the
sequence described below. Also, the controllers in the subsystem are not yet configured
for compatibility with HP-UX.
Class I
H/W
Path
Driver S/W State *H/W Type Desc.
fc 0 10/8 fcT1 CLAIMED INTERFACE HP FC Mass
Storage
Adapter
lan 1 10/8.6 fcT1_cnt CLAIMED INTERFACE HP FC Mass
Storage Cntl
fcp 0 10/8.8 fcp CLAIMED INTERFACE FCP Protocol
Adapter