HSG80 ACS Solution Software V8.6 for Compaq OpenVMS Installation and Configuration Guide

Configuration Procedures 5–9
For a recommended naming convention, see “Naming Connections,” page 1–9.
18. Specify the operating system for the connection:
SET ANGEL1A1 OPERATING_SYSTEM=VMS
19. Verify the changes:
SHOW CONNECTIONS
Mark or tag all Fibre Channel cables at both ends for ease of maintenance.
Repeat Procedure for Each Host Adapter
20. Repeat step 17, 18, and 19 for each of that adapter’s host connections, or delete the
unused connections from the table.
21. For each host adapter, repeat steps 16 through 20.
Verify Installation
To verify installation for your OpenVMS host, enter the following command:
SHOW DEVICES
Your host computer should report that it sees a device whose designation matches the
identifier (CCL) that you assigned the controller(s). For example, if you assigned an
identifier of 88, your host computer will see device $1$GGA88. This verifies that your
host computer is communicating with the controller.
Setting Up a Controller Pair
Power Up and Establish Communication
1. Connect the computer or terminal to the controller as shown in Figure 5–1. The
connection to the computer is through the COM1 or COM2 ports.
2. Turn on the computer or terminal.
3. Apply power to the storage subsystem.
4. Configure the computer or terminal as follows:
❏ 9600 baud
❏ 8 data bits
❏ 1 stop bit