HSG80 ACS Solution Software V8.6 for Compaq OpenVMS Installation and Configuration Guide

Configuration Procedures 5–15
The first connection will have one or more entries in the connection table. Each
connection will have a default name of the form !NEWCONxx, where xx is a number
representing the order in which the connection was added to the connection table.
For a description of why plugging in one adapter can result in multiple connections,
see “Numbers of Connections,” page 1–10.
17. Rename the connections to something meaningful to the system and easy to remember.
For example, to assign the name ANGEL1A1 to connection !NEWCON01, enter:
RENAME !NEWCON01 ANGEL1A1
Compaq recommends using a naming convention, see “Naming Connections,” page
1–9.
18. Specify the operating system for the connection:
SET ANGEL1A1 OPERATING_SYSTEM=VMS
19. Verify the changes:
SHOW CONNECTIONS
Mark or tag all Fibre Channel cables at both ends for ease of maintenance.
Repeat Procedure for Each Host Adapter Connection
20. Repeat steps 17, 18, and 19 for each of that adapter’s host connections or delete the
unwanted connections from the table.
21. For each host adapter, repeat steps 16 through 20.
Verify Installation
To verify installation for your OpenVMS host, enter the following command:
SHOW DEVICES
Your host computer should report that it sees a device whose designation matches the
identifier (CCL) that you assigned the controller(s). For example, if you assigned an
identifier of 88, your host computer will see device $1$GGA88. This verifies that your
host computer is communicating with the controller pair.