HSG80 ACS Solution Software V8.6 for SGI IRIX Installation and Configuration Guide

5–24 HSG80 ACS Solution Software Version 8.6 for SGI Irix Installation and Configuration Guide
Changing Initialize Switches
The initialization switches cannot be changed without destroying the data on the
storageset or device. These switches are integral to the formatting and can only be changed
by reinitializing the storageset. Initializing a storageset is similar to formatting a disk
drive; all data is destroyed during this procedure.
Changing Unit Switches
Use the SET unit-name command to change the characteristics of a unit.
For example, the following command enables write protection for unit D100:
SET D100 WRITE_PROTECT