HSG80 ACS Solution Software V8.6 for SGI IRIX Installation and Configuration Guide

Chapter 6
Configuration Example Using CLI
This chapter presents an example of how to configure a storage subsystem using the
Command Line Interpreter (CLI). The CLI configuration example shown assumes:
■ A normal, new controller pair, meaning:
❏ NODE ID set
❏ No previous failover mode
❏ No previous topology set
■ Two single-bus model 4214R disk enclosure shelves
■ PCMCIA cards installed in both controllers
Storage Subsystem Example
A storage subsystem example is shown in Figure 6–1. The example system contains three
non-clustered Irix hosts, as shown in Figure 6–2. The resulting virtual system, from the
host’s point of view, is shown in Figure 6–3.