HSG80 ACS Solution Software V8.6 for SGI IRIX Installation and Configuration Guide

3–10 HSG80 ACS Solution Software Version 8.6 for SGI Irix Installation and Configuration Guide
NOTE: To partition the device, follow the prompts and enter the answers displayed in the large
bold face italic type. The default answers are shown in ( ) braces. Press the Enter key to utilize
the default answer.
The controller number, drive number and LUN number of your drive will probably be different for
Arbitrated Loop or Fabric.
NOTE: The following entries are for Arbitrated Loop only.
#
fx -x
fx version 6.5, Dec 31, 2000
fx: “device-name” = (dksc)
dksc
fx: ctlr# = (0) 10
fx: drive# = (1) 64
fx: lun# = (0) 4
...opening dksc(10,64,4)
...drive selftest...OK
NOTE: The following entries are for Fabric only.
For Irix V6.5.9 or earlier, use:
#
fx – x – d /dev/rdsk/50001fe1000007e0/lun0vol/c5p50001fe1000007e1
For Irix V6.5.10 or later, use:
#
fx – x – d /dev/rdsk/50001fe1000007e0/lun0vol/c5p1
fx version 6.5, Dec 31, 2000
...opening c5p50001fe1000007e1
...drive selftest...OK
NOTE: The following entries are for both Arbitrated Loop and Fabric.
Scsi drive type == DEC HSG80 V86
fx: Warning: no sgilabel on disk
fx: Warning: can't read sgilabel on disk
creating new sgilabel
----- please choose one (? for help,. to quit this menu)-----
[exi]t [d]ebug/ [l]abel/ [a]uto
[b]adblock/ [exe]rcise/ [r]epartition/ [f]ormat
fx>
label
----- please choose one (? for help, .. to quit this menu)-----
[sh]ow/ [sy]nc [se]t/ [c]reate/
fx/label>
set
----- please choose one (? for help, .. to quit this menu)-----
[para]meters [part]itions [s]giinfo