HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Chapter 4
Installing and Configuring the HS-Series Agent
The following information is included in this chapter:
■ “Why Use StorageWorks Command Console (SWCC)?,” page 4–1
■ “Installation and Configuration Overview,” page 4–2
■ “Reconfiguring the Agent,” page 4–7
■ “Removing the Agent,” page 4–15
Why Use StorageWorks Command Console
(SWCC)?
StorageWorks Command Console (SWCC) enables you to monitor and configure the
storage connected to the HSG80 controller. SWCC consists of Client and Agent.
■ Client provides pager notification and lets you manage your virtual disks. Client runs
on Windows 2000 with Service Pack 1 and Windows NT 4.0 (Intel) with Service Pack
6A.
■ Agent obtains the status of the storage connected to the controller. It also passes the
status of the devices connected to the controller to other computers .
To receive information about the devices connected to your HSG80 controller over a
TCP/IP network, you must install the Agent on a computer that is connected to a
controller.