HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–3
3 ■ If you plan to connect the HSG80 to a computer running Windows NT 4.0 or Windows 2000
in SCSI-2 mode, you must disable the Command Console LUN (CCL) and create a virtual
disk by using the command line interface (CLI). For information on how to disable the CCL,
See “The Command Console LUN” in Chapter 1. For information on how to create a virtual
disk, see “Add Unit” in the Compaq StorageWorks HSG80 Array Controller ACS Version 8.6
CLI Reference Guide.
4 Install the Agent (TCP/IP network connections) on a system connected to the HSG80 controller.
See “Installing and Configuring the Agent,” page 4–5.
5 Add the name of the Client system to the Agent’s list of Client system entries (TCP/IP network
connections). This can be done during installation or when reconfiguring the Agent.
6 Install the Client software on Windows 2000 with Service Pack 1 or Windows NT 4.0 (Intel) with
Service Pack 6A.
7 Add the name of the agent system to the Navigation Tree of each Client system that is on the
Agent’s list of Client system entries (TCP/IP network connections).
8 Set up pager notification (TCP/IP network connections). Refer to “Setting Up Pager Notification”
in the Compaq StorageWorks Command Console Version 2.4 User Guide.
Table 4–2 Installation and Configuration Overview
Step Procedure