HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–9
4. Enter the name of the client system entry that you want to have access to this Agent in
the Selected Client field.
5. Select TCP/IP and/or SNMP for your notification scheme. For a definition of the
notification scheme, see Table 4–3 on page 4–6.
6. Select one of the following for your access privileges: overall status, detailed status,
and configuration. For a definition of each access privilege level, see Table 4–4 on
page 4–6.
7. Click Add Client to add the client system entry to the list of client system entries.
8. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window appears, go
to step 9.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the subsystem to update the
information? (Subsystem names will revert to default settings.)
If you click Yes, the software will automatically add entries for the new subsystems
and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.
9. Click Finish. The following message appears:
No subsystem information was added to the subsystem list. Subsystem list will not be created
or modified.
10. Click OK. The Welcome NT Agent Configuration Utility window appears.
11. Click Exit to quit the NT Agent Configuration Utility.
12. You must stop and restart the Agent for your changes to take effect. For instructions,
see “Stopping and Starting the Agent,” page 4–14.
Modifying a Client System Entry
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click Next to continue. You do not need to enter your password. The NT Agent
Configuration Step 2 of 3 window appears.