Manualshelf

HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

ManualsBrandsHP ManualsStorageHP StorageWorks EMA16000 D14 (opal) Bundle
121122123124125126127128129130
4–10 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
4. Select the client system entry that you want to modify. You can change your
notification scheme and/or your access privileges.
5. Click Modify Client to confirm your changes.
6. Click Next to continue. If the NT Agent Configuration Step 3 of 3 window appears, go
to step 7.
The following message appears if you had previously added a subsystem:
A previous storage list is detected. Would you like to scan the subsystem to update the
information? (Subsystem names will revert to default settings.)
If you click Yes, the software will automatically add entries for the new subsystems
and restore default subsystem information for the existing entries.
Or
If you click No, the software will keep the current settings.
The NT Agent Configuration Step 3 of 3 window appears.
7. Click Finish. The following message appears:
No subsystem information was added to the subsystem list. Subsystem list will not be created
or modified.
8. Click OK. The Welcome NT Agent Configuration Utility window appears.
9. Click Exit to quit the NT Agent Configuration Utility.
10. You must stop and restart the Agent for your changes to take effect. For instructions,
see “Stopping and Starting the Agent,” page 4–14.
Deleting a Client System Entry
When a you delete client system entry from the Agent’s list, the following occurs:
■ The Agent stops sending updates to that client system
■ You are unable to access this agent system from the Navigation Tree.
1. Open the HS Series Agent Configurator.
The Welcome NT Agent Configuration Utility window appears.
2. Click Continue. The NT Agent Configuration Step 1 of 3 window appears.
3. Click Next to continue. You do not need to enter your password. The NT Agent
Configuration Step 2 of 3 window appears.
4. Select the client system entry that you want to delete in the Selected Client field. Click
Delete Client.