HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Configuration Procedures 5–5
See “Worldwide Names (Node IDs and Port IDs),” page 1–27, for the location of the
sticker.
The node ID is located in the third line of the SHOW THIS result:
HSG80> SHOW THIS
Controller:
HSG80 ZG80900583 Software V8.6F-1, Hardware E11
NODE_ID = 5000-1FE1-0001-3F00
ALLOCATION_CLASS = 0
If the node ID is present, go to step 5.
If the node ID is all zeroes, enter the node ID and checksum, which are located on a
sticker on the controller enclosure. Use the following syntax to enter the node ID:
SET THIS NODE_ID=NNNN-NNNN-NNNN-NNNN nn
Where:NNNN-NNNN-NNNN-NNNN is the node ID, and nn is the checksum.
2. When using a controller that is not new from the factory, enter the following command
to take it out of any failover mode that may have been configured previously:
SET NOFAILOVER
If the controller did have a failover mode previously set, the CLI may report an error.
Clear the error with this command:
CLEAR_ERRORS CLI
3. Enter the following command to remove any previously configured connections:
SHOW CONNECTIONS
A list of named connections, if any, is displayed.
4. Delete these connections by entering the following command:
DELETE !NEWCON01
Repeat the Delete command for each of the listed connections. When completed, no
connections will be displayed.
Configure Controller Settings
5. Set the SCSI version to SCSI-3 using the following command:
SET THIS SCSI_VERSION=SCSI-3
NOTE: Setting the SCSI version to SCSI-3 does not make the controller fully compliant with the
SCSI-3 standards.
SET THIS SCSI_VERSION=SCSI-3