HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

7–6 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
Moving Storagesets
You can move a storageset from one subsystem to another without destroying its data. You
also can follow the steps in this section to move a storageset to a new location within the
same subsystem.
CAUTION: Move only normal storagesets. Do not move storagesets that are
reconstructing or reduced, or data corruption will result.
See the release notes for the version of your controller software for information on which
drives can be supported.
CAUTION: Never initialize any container or this procedure will not protect data.
Use the following procedure to move a storageset, while maintaining the data the
storageset contains:
1. Show the details for the storageset you want to move. Use the following command:
SHOW STORAGESET-NAME
2. Label each member with its name and PTL location.
If you do not have a storageset map for your subsystem, you can enter the
LOCATE
command for each member to find its PTL location. Use the following command:
LOCATE DISK-NAME
To cancel the locate command, enter the following:
LOCATE CANCEL
3. Delete the unit number shown in the “Used by” column of the SHOW storageset-name
command. Use the following syntax:
DELETE UNIT-NUMBER
4. Delete the storageset shown in the “Name” column of the SHOW storageset-name
command. Use the following syntax:
DELETE STORAGESET-NAME