HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

Planning a Subsystem 1–13
Enabling/Disabling CCL in SCSI-3 Mode
The CCL is enabled all the time. There is no option to enable/disable.
Connections
The term “connection” applies to every path between a Fibre Channel adapter in a host
computer and an active host port on a controller.
NOTE: In ACS V8.6 the maximum number of supported connections is 96.
Naming Connections
Compaq highly recommends that you assign names to connections that have meaning in
the context of your particular configuration. One system that works well is to name each
connection after its host, its adapter, its controller, and its controller host port, as follows:
Examples:
A connection from the first adapter in the host named RED that goes to port 1 of controller
A would be called RED1A1.
A connection from the third adapter in host GREEN that goes to port 2 of controller B
would be called GREEN3B2.
NOTE: Connection names can have a maximum of 9 characters.
HOST1A1
HOST
NAME
PORT
CONTROLLER
ADAPTER