HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

2–38 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
Using the LOCATE Command to Find Devices
If you want to complete a storage map at a later time but do not remember where all disk
drives, partitions, etc. are located, use the CLI command
LOCATE. The LOCATE command
flashes the (fault) LED on the drives associated with the specific storageset or unit. To turn
off the flashing LEDs, enter the CLI command
LOCATE CANCEL.
The following procedure is an example of the commands to locate all the disk drives that
make up unit D104:
1. Enter the following command:
LOCATE D104
The LEDs on the disk drives that make up unit D104 will flash.
2. Note the position of all the drives contained within D104.
3. Enter the following command to turn off the flashing LEDs:
LOCATE CANCEL
The following procedure is an example command to locate all the drives that make up
RAIDset R1:
1. Enter the following command:
LOCATE R1
2. Note the position of all the drives contained within R1.
3. Enter the following command to turn off the flashing LEDs:
LOCATE CANCEL