HSG80 ACS Solution Software V8.6 for Windows NT and Windows 2000 Installation and Configuration Guide

3–2 HSG80 ACS Solution Software Version 8.6 for Windows NT and Windows 2000 Installation and
Configuration Guide
Enterprise Storage RAID Array Storage
System Installation
WARNING: A shock hazard exists at the backplane when the controller enclosure
bays or cache module bays are empty.
Be sure the enclosures are empty, then mount the enclosures into the rack. DO NOT
use the disk enclosure handles to lift the enclosure. The handles cannot support the
weight of the enclosure. Only use these handles to position the enclosure in the
mounting brackets.
Use two people to lift, align, and install any enclosure into a rack. Failure to use two
people might cause personal injury and/or equipment damage.
CAUTION: Controller and disk enclosures have no power switches. Make sure the
controller enclosures and disk enclosures are physically configured before turning the
PDU on and connecting the power cords. Failure to do so can cause equipment
damage.
1. Be sure the enclosures are empty before mounting them into the rack. If necessary,
remove the following elements from the controller enclosure:
❏ Environmental Monitoring Unit (EMU) ❏ Power Supplies
❏ External Cache Batteries (ECBs) ❏ Fans
If necessary, remove the following elements from the disk enclosure:
❏ Power Supply/Blower Assemblies ❏ Disk Drives
❏ Environmental Monitoring Unit (EMU) ❏ I/O Modules
Refer to the Compaq StorageWorks Model 2100 and 2200 UltraSCSI Controller User
Guide, Compaq StorageWorks Enclosure 4200 Family LVD Disk Enclosure User
Guide, and Compaq StorageWorks Enclosure 4300 Family LVD Disk Enclosure User
Guide the for further information.
2. Install brackets onto the controller enclosure and disk enclosures. Using two people,
mount the enclosures into the rack. Refer to the mounting kit documentation for
further information.
3. Install the elements. Install the disk drives. Make sure you install blank panels in any
unused bays.