HP StorageWorks Enterprise Modular Library E-Series 71e Getting Started (AH876-96002, September 2007)

At the rear of the library, guide the notches on the

bottom corners of the 4U base module onto the

mounting brackets. Slide the 4U base module

completely into the rack.

At the front of the library, remove the 4U blank cover

from the 4U base module. Push down and pull the top

of the 4U blank cover away from the front of the

library. Lift the cover off.

Attach the 4U base module to the front of the rack with

four T-25 panhead screws.

Open the center doors on the two modules. Align the

tongue of the lower door with the groove in the upper

door. Carefully slide the 4U base module into the rack

until the doors are engaged.

Attach the faceplate of the 4U base module to the

faceplate of the 8U base module with two 6/32 x

1/4-inch Torx screws.

CAUTION! Use the correct length screw for this

step. The robot will hit a longer screw when it

descends.