HP StorageWorks Enterprise Modular Library E-Series 71e Getting Started (AH876-96002, September 2007)

Plug in the two ends of the power cable.
Replace the arrays inside the library.
At the rear of the library, loosen the thumbscrew and
remove the cover from the bottom-left corner of the 8U
base module.
Plug in the interconnect cable
29
Install the cover from the 4U base module (removed in
step 14) onto the two modules. Tighten the two
thumbscrews to secure the cover.
31
30
Pull the ribbon cable out of the 8U base module. Plug the
ribbon cable into the 4U base module.
27
28
WARNING! Before doing this step, make sure
the main power switch is Off and the 8U base
module is not plugged in.
Install the robotics unit
32
Remove the shipping restraints. Put the robot upside down
on a table. Remove the two shipping straps from the slots
on the front and back of the robotics unit. Store the
shipping straps with the other packaging materials. Pull up
on the yellow gear lock to disengage it from the reduction
gear. The gear lock remains attached to the robotics unit.
WARNING! The robotics unit weighs 11 kg (25 lb).
Be careful when lifting. Use a cart, tabletop, or
mechanical device to lift, position, and secure
the module.