HP StorageWorks EML E-Series e2400-FC 4Gb interface controller replacement (AD569-96006, December 2007)

ManualsBrandsHP ManualsComputer AccessoriesHP StorageWorks EML e2400-FC 4Gb Interface Controller

EML E-Series e2400-FC 4Gb

interface cont

roller replacement

This document contains instructions for how to replace

an e2400-FC 4Gb interface controller in an EML

E-Series library.

L.P.

Third edition: November 2007

The info

rmationinthisdocumentissubjecttochangewithout

notice.

Printed in the US

www.hp.com

569-96006

CAUTION:

Parts can be damaged by electrostatic discharge. Keep parts in

theircontainersuntilneeded. Makesurethatyouareproperly

grounded when touching static sensitive components.

CAUTION:

This part is not hot-pluggable. It is necessary to power down

the library to replace this part.

When installi

ng the interface controller, additional insertion force

is needed to se

at this card.

CAUTION:

To support the added cooling requirements of the e2400-FC 4Gb

interfacecontroller,thebasemoduleinthelibrarymustcontain

two 12V fans instead of the two 5V fans that some of the units

shipped with. To see which size fans your library contains, when

the library is powered off, view the model number on the fan

which is visible from the rear of the library:

• 5V fan – AFB0605HC

• 12V fan – F FB0612EHE

The part number for the 12V fans is 409861-001 which includes

two fans.

All units of the card cage expansion module shipped with 12V

fans, so r

eplacing the fans in that module is not necessary.

1Poweroffthelibrary

a. Verify th at all jobs have completed processing.

b. Using the Operator Control Panel (OCP), select Operations >

Unlock Door. The robot is now parked.

c. Open the back doors of the library.

d. Press the main power switch to the O (Off) position.

2Loca

te the interface controller

Locat

e the interface controller that you want to replace in the second

card c

ageslotinthebasemoduleorinoneoftheslotsinthecard

cage expansion module. This interface controller has an FC0, FC1,

TD0, TD1, TD2, TD3, one Ethernet, and one serial port. You will need

a #1 Phillips screwdriver to remove and replace this card.

newpage pi

Page 1

Summary of content (3 pages)

PAGE 1
EML E-Series e2400-FC 4Gb interface controller replacement CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Make sure that you are properly grounded when touching static sensitive components. CAUTION: This part is not hot-pluggable. It is necessary to power down the library to replace this part. When installing the interface controller, additional insertion force is needed to seat this card.
PAGE 2
3 Unplug the cables 6 Connect the cables Label the cables or write a note that shows the locations of all the cables plugged into the interface controller to make it easier to reconnect them later. Unplug all cables from the interface controller by pressing on the connector tabs and removing the cables. Plug the cables into the interface controller exactly as they were plugged into the original interface controller (see the labels on the cables or the note that you wrote).
PAGE 3
9 Verify the LEDs Make sure that the power LED and the Fibre Link LEDs on the interface controller are solid green. The link LEDs indicate a good connection. 10 Close the back doors of the library 11 Update the firmware Use HP StorageWorks Command View TL or the CLI to make sure that the new interface controller is detected, and to perform configuration and firmware updates, if necessary. Refer to the HP StorageWorks Interface Manager and Command View TL user guide for detailed procedures.