HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Deployment Guide (407118 - 003, June 2006)
8 INTRODUCTION
Chapter 2, “In-Path Deployments,” describes physical in-path deployments.
Chapter 3, “Virtual In-Path Network Deployments,” describes virtual in-path
deployments.
Chapter 4, “Out-of-Path Network Deployments,” describes out-of-path
deployments.
Chapter 5, “Configuring Connection Forwarding,” describes how to configure the
HP EFS WAN Accelerator to forward connections in asymmetric networks.
Chapter 6, “Policy-Based Routing Deployments,” describes how to configure the
HP EFS WAN Accelerator for deployments using PBR, Cisco Discovery Protocol
(CDP), and autodiscovery.
Chapter 7, “WCCP Deployments,” describes how to configure the HP EFS WAN
Accelerator and routers for WCCP.
Chapter 8, “Proxy File Service Deployments,” describes how to configure the HP
EFS WAN Accelerator to perform PFS.
Chapter 9, “RADIUS and TACACS+ Authentication,” describes how to
configure Remote Authentication Dial-In User Service (RADIUS) or Terminal
Access Controller Access Control System (TACACS+) authentication for the HP
EFS WAN Accelerator.
Chapter 10, “Serial Cluster and Cascade Deployments,” describes how to
configure the HP EFS WAN Accelerator in serial and cascade clusters to increase
optimization.
Chapter 11, “Troubleshooting Deployment Problems,” describes common
deployment problems and possible solutions.
A glossary of terms follows the chapters, and a comprehensive index directs you to
areas of particular interest.