HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Deployment Guide (407118 - 003, June 2006)

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.7 DEPLOYMENT GUIDE 109
9 - RADIUS AND TACACS+
A
UTHENTICATION
Configuring TACACS+ Authentication
in the HP EFS WAN Accelerator
The following section provides the basic steps for configuring TACACS+
authentication in the HP EFS WAN Accelerator.
Configuring
TACACS+
Authentication
The following section describes the basic steps for configuring TACACS+
configuration in the HP EFS WAN Accelerator.
You prioritize TACACS+ authentication methods for the system and set the
authorization policy and default user.
IMPORTANT: Make sure to put the authentication methods in the order in which you want
authentication to occur. If authorization fails on the first method, the next method is attempted,
and so forth, until all the methods have been attempted.
Basic Steps The following section describes the basic steps for configuring TACACS+
authentication in the HP EFS WAN Accelerator.
1. Configure the HP EFS WAN Accelerator. For detailed information, see the HP
StorageWorks Enterprise File Services WAN Accelerator Installation and
Configuration Guide.
2. Connect to the Management Console. For detailed information, see the HP
StorageWorks Enterprise File Services WAN Accelerator Installation and
Configuration Guide.
3. Navigate to the Setup: Authentication - General Settings page in the Management
Console.
4. Define the authentication methods. Make sure you put the authentication methods
in the order in which you want them to occur. If authorization fails on the first