HP StorageWorks Enterprise File Services WAN Accelerator 2.1.7 Management Console User Guide (392359-004, June 2006)

40 2 CONFIGURING THE HP EFS WAN ACCELERATOR
Setting Host Parameters
This section describes how to set host parameters for the HP EFS WAN Accelerator.
It includes the following topics:
 “Setting the Primary Interface,” next
 “Setting In-Path Interfaces” on page 42
 “Setting Auxiliary Interfaces” on page 46
 “Setting Main Static Routes” on page 48
 “Setting Static In-Path Routes” on page 49
 “Setting the DNS” on page 50
 “Mapping Hosts to IP Addresses” on page 53
 “Setting Proxies” on page 54
Setting the
Primary
Interface
You modify settings for the primary interface in the Host Settings - Interface Primary
page.
IMPORTANT: The primary and in-path interfaces can share the same subnet. The primary and
auxiliary interfaces cannot share the same network subnet.
NOTE: You were prompted to configure the primary interface when you completed the
installation wizard. This section describes how you can modify these settings.