HP StorageWorks ESL E-Series Tape Library Unpacking and Installation Guide (350800-011, May 2010)

CAUTION:
Do not overtighten the screws that secure the cable to the drive port.
b. Route each cable through the cable access holes in the sheet metal on the right of the library
cabinet.
For drive clusters 0 through 2, dip the excess cable length down into the upper cable access
hole. For drive clusters 3 through 5, route the cables up through the lower and upper access
holes. Push the first set of cables to the back of the library to create space for additional
cables. This will help prevent the cables from becoming tangled. See Figure 27.
Figure 27 Managing drive SCSI cables
.
CAUTION:
When routing cables through the cable access holes, be careful not to dislodge or damage
the I
2
C cable attached to the cluster controller card.
HP StorageWorks ESL E-Series Tape Library 37