HP StorageWorks ESL E-Series Tape Library Unpacking and Installation Guide (350800-011, May 2010)

c. Continue routing the cable up through the cable restraint bracket located to the right of the
card cage and attach the cable to the corresponding SCSI port on the e2400-160 interface
controller.
NOTE:
Tighten the SCSI connector screw on the left and then the right for easier installation due to
cable interference. Pull the cable toward you to provide more clearance when tightening
the right connector screw.
d. Repeat these steps until all SCSI drives are connected.
e. If you have a partially filled cluster, route the SCSI cables for the drives that are not present
in preparation for adding them in the future.
Installing the library38