HP StorageWorks ESL E-Series Tape Library Unpacking and Installation Guide (350800-011, May 2010)
Table Of Contents
- HP StorageWorks ESL E-Series Tape Library
- 1 Unpacking the library
- 2 Installing the library
- 3 Loading tape cartridges
- 4 Configuring the library
- 5 Support and other resources
- Index
4 Configuring the library
1. Make sure the library is powered on. If it is not:
a. On the front of the library, push the power button to turn on the library (the button will de-
press). The library will take 20 minutes or more to boot, depending on the configuration.
b. Verify that the current state of the library that appears on the OCP is “Online, OK”.
2. Power button1. Front door latch
Figure 42 Powering on the library
.
2. Take the library off-line, if it is not off-line already.
a. Press the Ops button on the OCP to access the Operations screen.
b. Select Cabinet.
c. Use the Up and Down buttons to take the library off-line.
HP StorageWorks ESL E-Series Tape Library 61