HP StorageWorks ESL E-Series Tape Library Unpacking and Installation Guide (350800-011, May 2010)
Table Of Contents
- HP StorageWorks ESL E-Series Tape Library
- 1 Unpacking the library
- 2 Installing the library
- 3 Loading tape cartridges
- 4 Configuring the library
- 5 Support and other resources
- Index
1 Unpacking the library
This chapter contains the following sections:
• “Selecting an installation location” on page 9
• “Preparing for the installation” on page 13
• “Unpacking the library” on page 14
• “Setting up the library” on page 23
• “Storing the packaging materials” on page 32
CAUTION:
Only qualified HP field service engineers should unpack the HP StorageWorks ESL E-Series tape
library.
Selecting an installation location
When choosing an installation site for the HP StorageWorks ESL E-Series tape library, consider the
requirements described in:
• “Floor space” on page 10
• “Floor clearance” on page 11
• “Floor strength and inclination” on page 11
• “Power and grounding” on page 12
• “Environmental conditions” on page 13
NOTE:
These requirements are also described in the
HP StorageWorks ESL E-Series Tape Library User
Guide
.
HP StorageWorks ESL E-Series Tape Library 9