HP StorageWorks ESL E-Series Ultrium 1840 FC tape drive upgrade or replacement (AH194-96001, October 2007)

3.6 Configure the new tape drive
Use Command View TL or the Interface Manager CLI to enter the host
mapping, access control, and FC speed settings for the new tape drive.
See the HP StorageWorks Interface Manager and Command View TL
User’s Guide for detailed procedures.
On the OC P, verify that the number of con figured drives in the library is
correct. If the number of configureddrivesisincorrect,usetheOCPto
change the number. This will require a library reboot.
3.7 Configure
the SAN switch
Rezone the SA
N, if necessary, to account for the new hardware and
paths.
Reboot the S
AN FC switch if necessary.
3.8 Verify connectivity
11571
Verify t
hat the F C port A LED on the new tape drive is green when
connect
ed to a switch and linked.
3.9 Close the library
10010
Close the back door of the library.
3.10 Upgrade the tape drive firmw are
Ensure that the tape drive has the latest firmware for correct operation.
If necessary, upgrade the drive firmware using the Command View
TL firmware upgrade wizard or the Interface M anager’s Command
Line Interface. See the HP StorageWorks Interface Manager and
Command View TL User’s Guide for detailed procedures on upgrading
drive firmware.
Page 3