HP StorageWorks EVA iSCSI Connectivity User Guide (5697-0511, August 2010)

4. Enable the iSCSI software initiators:
a. In VMware’s VI client, select the server from the inventory panel.
b. Click the Configuration tab, and then click Storage Adapters under Hardware.
c. Under iSCSI software Adapter, choose the available software initiator.
d. Click the Properties link of the software adapter.
e. The iSCSI initiator properties dialog box is displayed. Click Configure.
f. The General properties dialog box displays (Figure 40). Select the Enabled checkbox .
Figure 40 General properties dialog box
.
g. Click OK.
5. Set up Discovery Addressing for the software initiator:
a. Repeat Step 4 to open the iSCSI initiator Properties dialog box.
b. Click the Dynamic Discovery tab.
c. Click Add to add a new iSCSI target. The Add Send Target Server dialog box is displayed.
d. Enter the mpx100’s/100b's iSCSI IP address (Figure 41) and then click OK.
Figure 41 Add send targets server dialog box
.
6. See Creating an iSCSI initiator host via HP Command View EVA, page 128 for instructions to
change the host mode of the VMware initiator to VMware.
EVA iSCSI Connectivity User Guide 91