HP 30-10022-01 Loop Switch User Guide (5697-5674, May 2006)

44 CLI Quick Reference
Frequent Switch Configuration Tasks
A list of frequent switch configuration-related tasks is provided below. The list displays the task and
the corresponding CLI command.
CLI Commands
All of the CLI commands for the 30-10022-01 loop switch are shown below in a tree diagram. Using
the “help” command at the command line may provide additional information.
To… Type…
View switch information show sysinfo
Change general switch configuration config sys
Change the IP Address config network ip
Change a port’s speed config port speed
View the event log show events
Upgrade the firmware fw
Change the port settings config port
Reset the switch reset
View diagnostics diag
View port statistics information show stat
Reset the switch to factory default settings config default
Change the password config password
root -->
li
lo
1. config --> 1. sys --> 1. time
2. name
3. location
4. contact
5. events
6. sev
7. fault
8. evclr
9. clrled
10. syslog
11. cfgdump
12. cfgload
13. ..
14. ?
2. sesalpa
3. default
4. port --> 1. beacon
2. enable
3. speed
4. lip
5. ..
6. ?
5. password
6. network 1. show
2. dhcp
3. ip
4. mask
5. gateway
6. reset
7. ..
8. ?
7. ..
8. ?
2. diag --> 1. galpa
2. prtctrs
3. clrctr
4. beacon
5. ..
6. ?
3. show --> 1. events
2. speeds
3. prtctrs
4. prtutilization
5. clrctr
6. sysinfo
7. galpa
8. sensors
9. sid
10. stat
11. dump
12. ..
13. ?
4. fw --> 1. tftp
2. xmodem
3. revert
4. show
5. reset
6. ..
7. ?
5. reset
6. ?