HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

12 Configuration Menu (CONFIG)
To change the password:
1. From the Configuration menu (config), type password and press E
NTER.
A message prompt is displayed asking for the current password.
2. Type the current password and press E
NTER.
If the correct password is entered, a message prompt is displayed asking for the new
password.
NOTE: The new password must be between 1 and 80 characters in length and is case sensitive.
3. Type the new password and press ENTER.
A message prompt is displayed asking for the new password to be entered again.
4. Type the new password and press E
NTER.
The new password is saved and activated.
Return to Previous Menu (..)
This command enables you to return to the previous menu.
To return to the previous menu:
Type .. and press E
NTER.