HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

30-10022-01 loop switch CLI reference guide 15
Configuring the Event Log Severity Fault Threshold (config/sys/fault)
This command sets the threshold for when the Fault LED is triggered by an event. When set, an
event that is equal to or higher than the specified fault threshold will trigger the switch’s Fault LED.
The default setting is 3.
Each event has a particular severity level ranging between “emergency” and “info”. You can
designate the lowest severity level at which to trip the switch’s Fault LED.
To change the event log severity level:
1. From the System Configuration menu (config/sys), type fault and press E
NTER.
The current fault threshold value is displayed in brackets before the command prompt.
2. Type the desired selection (1-7) and press E
NTER.
Clearing the Event Log (config/sys/evclr)
This command deletes all event log messages currently recorded in the log.
To delete the current list of event log messages:
1. From the System Configuration menu (config/sys), type evclr and press E
NTER.
A message prompt is displayed confirming the request.
2. Type y and press E
NTER.
The event log is cleared and a new event message is displayed reporting that the event log
has been cleared.
Clearing the Fault LED (config/sys/clrled)
This command clears the switch’s Fault LED.
To clear the switch’s Fault LED:
From the System Configuration menu (config/sys), type clrled and press E
NTER. The Fault LED turns
off.
Configuring the Switch for a Syslog Server (config/sys/syslog)
This command configures the switch for a syslog server that monitors switch events.
To configure the switch to communicate with a syslog server:
From the System Configuration menu (config/sys), type syslog and press E
NTER.
2 alert
3critical
4error
5 warning
6notify
7 information
Setting Description
Setting Description
1 emergency
2 alert
3critical
4error
5 warning
6notify
7 information