HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

8Introduction
To change the default gateway setting:
1. From the Network Configuration menu (config/network), type gateway and press E
NTER.
2. Type the new default gateway setting and press E
NTER.
Changing the Switch Password
NOTE: Until the default switch password is changed, any person with knowledge of the default password
can make changes to the switch’s configuration.
To change the password:
1. From the Configuration menu (config), type password and press E
NTER.
2. Type the current password and press E
NTER. The default password is “password”.
NOTE: The new password must be between 1 and 80 characters in length and is case sensitive.
3. Type the new password and press ENTER.
4. Type the new password again and press E
NTER.
Setting the Time and Date
To view the current date and time:
From the Root menu, type show sysinfo and press E
NTER.
To change the date and time:
1. From the System Configuration menu (config/sys), type time and press E
NTER.
2. Type the new date and time (MM/DD/YYYY HR:MN:SC) and press E
NTER.
Resetting the Switch
To reset the switch:
From the Root menu, type reset and press E
NTER.