HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

30-10022-01 loop switch CLI reference guide 9
CLI Command Reference Diagram
The diagram below displays the available CLI commands and their hierarchical structure.
Root Menu (root)
The Root menu is the CLI’s main menu. This menu is the first menu displayed after entering the
password and logging in to the CLI.
Hardware Reset (reset)
This command resets the switch. Current switch configuration settings are retained after the reset.
To reset the switch:
1. From the Root menu, type reset and press E
NTER.
A confirmation request is displayed.
2. Type y and press E
NTER to proceed with the switch reset.
root -->
li
lo
1. config --> 1. sys --> 1. time
2. name
3. location
4. contact
5. events
6. sev
7. fault
8. evclr
9. clrled
10. syslog
11. cfgdump
12. cfgload
13. ..
14. ?
2. sesalpa
3. default
4. port --> 1. beacon
2. enable
3. speed
4. lip
5. ..
6. ?
5. password
6. network 1. show
2. dhcp
3. ip
4. mask
5. gateway
6. reset
7. ..
8. ?
7. ..
8. ?
2. diag --> 1. galpa
2. prtctrs
3. clrctr
4. beacon
5. ..
6. ?
3. show --> 1. events
2. speeds
3. prtctrs
4. prtutilization
5. clrctr
6. sysinfo
7. galpa
8. sensors
9. sid
10. stat
11. dump
12. ..
13. ?
4. fw --> 1. tftp
2. xmodem
3. revert
4. show
5. reset
6. ..
7. ?
5. reset
6. ?
Menu Command Description Additional Information
1. config Displays the Configuration sub-menu. See page 7.
2. diag Displays the Diagnostics sub-menu. See page 18.
3. show Displays the Show sub-menu. See page 19.
4. fw Displays the Firmware sub-menu. See page 25.
5. reset Resets the switch. See page 9.
6. ? Displays the current menu. See page 10.