hp StorageWorks fca2355 dual channel PCI host bus adapter - installation guide

2–2 fca2355 dual channel PCI host bus adapter installation guide
Installation
Record the addresses on the lines below for future reference.
First IEEE address: __________________________________________________
First Serial number: __________________________________________________
Second IEEE address: __________________________________________________
Second Serial number: __________________________________________________
Installing the HBA into a Computer
Following is the procedure for installing the HBA into a computer.
WARNING:
Be sure to observe the ESD precautions for this procedure.
1. Make sure the computer is powered off.
2. Remove the screws on the computer cover, and then remove the cover.
3. Wearing a static wrist strap, remove the blank panel from an empty 32- or 64-bit
PCI bus slot.
4. Insert the HBA into the empty 32-bit or 64-bit PCI bus slot; press firmly until it is
seated securely.
5. Secure the HBA mounting bracket to the computer panel with the panel screws.
6. Replace the computer cover and secure it using the previously removed screws.
7. Attach media:
a. Connect the fiber optic cable to the LC connector on the HBA.
b. Connect the other end of the cable to the Fibre Channel device.
NOTE: The HBA does not allow normal data transmission on an optical link unless it is
connected to a similar or compatible laser product. That is, both products are multimode to
multimode.