hp StorageWorks fca2355 dual channel PCI host bus adapter - installation guide

fca2355 dual channel PCI host bus adapter installation guide 4–3
Troubleshooting
Table 4–2 describes the SCSI port error log codes
Table 4–2: SCSI Port Error Log Codes
0x10
Offset Explanation 0x11 to 0x13 Further Information
0xC0 Invalid Link Speed Selection
(Windows NT)
0xD0 SNS_REQ (XMIT_SEQ failed) 0x11 = cmdstat, 12 = parm err
0xD1 SNS_RSP (RCV_SEQ failed) 0x11 = cmdstat, 12 = parm err
0xD3 RCV_ELS_REQ failed 0x11 = cmdstat, 12 = parm err
0xD4 XMT_ELS_REQ failed 0x11 = cmdstat, 12 = parm err
0xD5 Too many targets found (160+) 0x11 to 13 = D_DID that didn’t fit
0xD6 SNS request time-out 0x11 to 13 no additional information
0xD7 Mailbox interrupt time-out 0x11 = mailbox word 0
0xD8 TPRLO requested when busy 0x11 = local req. state, 12 = discstate,
13 = mailbox word 0
0xD9 Link down time-out occurred 0x11 = local req. state, 12 = discstate,
13 = mailbox word 0
0xDA Hard link down time-out occurred 0x11 = local req. state, 12 = discstate,
13 = mailbox word 0
0xE0 Node purged from configuration
(Windows NT)
0x11 to 0x13 = D_ID of node purged
0xE1 Error interrupt occurred Status register bytes 1-3 in event 11-13.
E1 error indicates an HBA hardware
failure, return HBA for repair.
0xE2 Mailbox cmd time-out 0x11 = command
0xE3 Mailbox rsp err 0x11 = command, 12-13 = mbxstatus
0xE4 HBA not ready after init Status register bytes 1-3 in event 11-13
0xE5 Requested loop but link = PT-PT
0xE6 Mailbox int. but cmd not complete 0x11 = MB cmd, 12-13 = mbxstatus
0xE7 SRB already queued to ring
0xE8 RESTART failed
0xE9 PORT BYPASS (LPB) received
0xEB Unknown IOCB cmd rsp 0x11 = 15:8 = cmd field